Moods’4 series of Microprocessor based Digital Electronic Dimmers are designed to control the intensity of lights in Public Areas of Hotels, Restaurants, etc. These dimmers are used to create ambience of Moods matching to the need of the hour or occasion, by just touch of a button. Digital Dimmers are far superior to Analogue Dimmers in respect of precision, reliability, repeatability, and flicker-free operation even on very small loads. The dimmers can be controlled from a computer and integrated with the Building Management System (BMS).

Technical Specification

1. Main voltage :- 230 Volts (for Single Phase), 415 Volts (for Three Phase)
2. Main Frequency :- 50 Hz, AC
3. Mains Quality :- Incoming supply should be Sine Wave
Free from distortion & harmonics
4. Soft-Start rate :- User Defined, Default: 6 seconds
5. Cross-Fade Rate :- User Defined, Default: 6 seconds
6. Dimming range :- 0 to 100% in steps of 2%
7. Device for Dimming :- Industrial Grade Microcontroller
8. Operating Temperature :- 10 to 45 degree C
9. Relative Humidity:- 90% without condensation
10. Backup:- Battery Backup for Memory Retention of Data
11. Addressing:- DIP Switch addressing, to a maximum of 64 channels
12. Maximum Load :- 1500 / 2000 watt per channel
13. Method of Dimming :- Phase Control by optically isolated Back to Back Thyristor module
14. Mains Signal Filtering :- Over 400 Hz is being filtered by RC circuit
15. Incoming Protection :- TPN MCB & 2 P ELECBs
15. Outgoing Protection :- MCB
15. Installation Precaution :- Lamp neutral must be derived from the Dimmer Panel Bus Bar
15. Load Type :- All Incandescent Lamps Low voltage Halogen Lamps with dimmable Transformer suitable for phase control Fluorescent Tubes PL Lamps with Dimmable Ballasts.